两点源干扰,Interference of dual sources
1)Interference of dual sources两点源干扰
1.Interference of dual sources is an effective means of counteracting Passive Radar Seeker (PRS).两点源干扰是干扰雷达导引头的重要手段。
英文短句/例句
1.An Improved Clustering Analysis Algorithm for Passive Radar to Resist Dual-source Jamming被动雷达抗两点源干扰的改进聚类分析法研究
2.Efficiency evaluation of multi-jamming sources on stand-off jamming based on the exposed range基于最小干扰距离的多点源支援干扰效果评估
3.image interference图像干扰;镜像干扰;镜像干扰;影频干扰;虚源干涉
4.The main interference source is spark plug, high-voltage ignition coil cap and the high-voltage coil.主要干扰源是火花塞、压点火线帽和高压点火线。
5.Analysis of Powers for SAR Active Coherent Jamming and Incoherent JammingSAR有源相干干扰和非相干干扰功率分析
6.Jammers Tracked by Azimuth Crossings方位交叉跟踪干扰源
7.Multi-band disturbing technique based on foam interfering screen基于泡沫型干扰幕的多波段无源干扰技术
8.Research on Coordinated Operational Application between Confusion Jamming and Active Jamming in Ship Formation编队迷惑干扰与有源干扰协同使用研究
9.Research on Least Jamming Distance of Shipborne Radar in Some Factors舰载雷达有源压制干扰最小干扰距离研究
10.The Allocation of Jamming Resource for Phased Array Jammer to Air-Defence Radar Nets相控阵干扰机干扰防空雷达网资源分配
11.An analysis on interference source and anti-interference measures for DCS system in paper enterprices造纸企业DCS系统干扰源分析与抗干扰措施
12.Research on Angle Deception Using Interference of Coherent Dual-Sources to Angle Tracking of Mono-Pulse相干两点源对单脉冲角跟踪诱偏方向的研究
13.Furthermore, the sticking points of the key techniques in millimeter wave active jamming design are introduced, and the solutions are also proposed.介绍了毫米波有源干扰机设计中的一些关键技术难点,提出了解决方法。
14.According to the characteristics of the millimeter wave radar, the possibility to conduct active jamming towards millimeter wave radar is discussed.根据毫米波雷达的特点,对毫米波雷达实施有源干扰的可行性进行了分析。
15.Being a deformation measurement with high resolution, borehole tiltmeters should be installed far away from disturbance sources as far as possible.作为一种高精度的形变观测，钻孔倾斜观测点必须尽可能避开干扰源。
16.This interference can be between 2 completely different viruses heterologous interference.发生在两种完全不同的病毒之间的干扰称为异种干扰。
17.Adaptive output power minimizes interference.可变的电源输出使干扰减小到最
18.Capacitor for electromagnetic interference suppression of AC power supply抑制电源电磁干扰用电容器
相关短句/例句
interference of coherent dual-sources相干两点源干扰
3)point-source jamming点源干扰
4)double-point-source interference双点源干扰
5)coherent dual sources相干两点源
1.From the phase-comparison angle measurement principle in monopulse PRS,the angle measurement mathematical model of phase-comparison PRS tracingcoherent dual sources is proposed,the PRS angle measurement performance with decoy of coherent source is analyzed.从比相单脉冲测向体制出发,推导出比相体制PRS跟踪相干两点源的数学模型,对两点源诱偏下被动雷达导引头的测角性能进行了分析,指出比相体制导引头无法分辨雷达和相干源诱饵,PRS将跟踪雷达和诱饵的合成相位中心,跟踪角度不固定且不断变化。
6)incoherent dual point-source非相干两点源
1.Based on the existing study ofincoherent dual point-source counteracting anti-radar missile (ARM),the attacking process of ARM was researched through analyzing the homing and moving theory of ARM,and the error distance of ARM disturbed by dual point-source was probed into.结合现有非相干两点源抗反辐射导弹模型的研究成果,通过分析反辐射导弹的导引和运动机理,进一步细化了反辐射导弹的攻击过程,在此基础上对两点源干扰下的反辐射导弹误差距离进行了探讨。
延伸阅读
传感器如何进行无源校准及两点特别说明a)首先读出变送器内部设置的4mA压力值和20mA压力值，看是否与实际的4mA压力值和20mA压力值相一致，若一致，则直接更改4mA压力值和20mA压力值到量程迁移后的压力值即可。 b)如果变送器内部设置的4mA压力值和20mA压力值，与实际的4mA压力值和20mA压力值不一致，可先把实际的4mA压力值和20mA压力值折算到变送器内部设置的4mA压力值和20mA压力值，再折算量程迁移后的压力值，将折算值更改到4mA压力值和20mA压力值便可。例如：假设一台变送器量程为-10bar－50bar，想将量程迁移到10bar-40bar，读出变送器内部设置的4mA 压力值和20mA压力假设为0-10Kpa,进行如下折算：－10bar 和0相对应,50bar和10Kpa相对应，通过计算，可以计算出折算方程为：P折＝P实/6＋10/6("P折"为折算后的压力值，"P实"为实际压力值）,由此方程可计算出折算后4mA压力值应为：10/6+10/6=3.333KPa,折算后20mA的压力值应为：40/6+10/6=8.333KPa, 于是可以通过组态软件将变送器内部的4mA压力值设置为3.333,将20mA压力值设置为8.333便可。特别说明： 1）量程迁移只能在原量程范围内迁移，若迁移超出原量程范围，则变送器的线性度变会变差。 2）进行无源校准时，量程迁移不可过大，迁移比最好不要大于3:1，过大会造成变送器输出不稳定，而且分辨率较低。大迁移比量程迁移在要先进行增益设置，再进行输入压力校准。
